FRONT DOOR LOCK INSTALLATION

PROCEDURE

  1. INSTALL FRONT DOOR INSIDE LOCKING CABLE ASSEMBLY LH

    Click here

  2. INSTALL FRONT DOOR LOCK REMOTE CONTROL CABLE ASSEMBLY LH

    Click here

  3. INSTALL FRONT DOOR LOCK ASSEMBLY LH

    Note:

    • When reusing the removed front door lock assembly, replace the door lock wiring harness seal on the connector with a new one.

    • Do not allow grease or dust to adhere to the surface of the connector which contacts the door lock wiring harness seal.

    • Reusing the door lock wiring harness seal or using a damaged door lock wiring harness seal may allow water into the connection. This may result in a malfunction of the front door lock assembly.

    1. Apply MP grease to the sliding parts of the front door lock assembly.

    2. Install a new door lock wiring harness seal to the front door lock assembly.

    3. B249833C01

      *a

      Slide

      Insert the front door lock open rod to the front door lock assembly.

    4. Check that the front door lock open rod is securely connected to the front door lock assembly.

    5. Using a T30 "TORX" wrench, install the front door lock assembly with the 3 screws.

      5.0 N*m

      51 kgf*cm

      44 in.*lbf

    6. Connect the connector.

  4. INSTALL FRONT DOOR OUTSIDE HANDLE COVER WITH LOCK CYLINDER ASSEMBLY

    Click here

  5. INSTALL FRONT DOOR REAR LOWER FRAME SUB-ASSEMBLY LH

    Click here

  6. INSTALL FRONT DOOR GLASS RUN LH

    Click here

  7. INSTALL FRONT DOOR GLASS SUB-ASSEMBLY LH

    Click here

  8. INSTALL FRONT DOOR SERVICE HOLE COVER LH

    Click here

  9. INSTALL FRONT NO. 1 SPEAKER ASSEMBLY

    Click here

  10. INSTALL FRONT DOOR INNER GLASS WEATHERSTRIP LH

    Click here

  11. INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH

    Click here

  12. INSTALL POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY WITH FRONT DOOR BASE PANEL

    Click here

  13. INSTALL FRONT ARMREST ASSEMBLY LH

    Click here

  14. INSTALL FRONT DOOR INSIDE HANDLE BEZEL PLUG LH

    Click here

  15. INSTALL FRONT DOOR LOWER FRAME BRACKET GARNISH LH

    Click here

  16. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click hereClick hereClick hereClick here).

  17. CHECK SRS WARNING LIGHT

    1. Check the SRS warning light (Click here).