CENTER AIRBAG SENSOR ASSEMBLY INSTALLATION

PROCEDURE

1. INSTALL CENTER AIRBAG SENSOR ASSEMBLY

   1. Turn the engine switch off.

   2. Disconnect the cable from the negative (-) battery terminal.

      CAUTION:

      Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

      Note:

      • After turning the engine switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click hereClick hereClick here).

      • When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click hereClick hereClick hereClick here).

   3. Install the airbag sensor with the 3 bolts.

      18 N*m

      184 kgf*cm

      13 ft.*lbf

      Note:

      • If the airbag sensor has been dropped, or there are any cracks, dents or other defects in the case, bracket or connector, replace it with a new one.

      • When installing the airbag sensor, be careful that the SRS wiring does not interfere with other parts and that it is not pinched between other parts.

   4. Check that the airbag sensor is not loose.

   5. Connect the connector.

2. INSTALL REAR CONSOLE BOX ASSEMBLY

   1. Install the console box assembly (Click hereClick here).

3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

   Note:

   When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click hereClick hereClick hereClick here).

4. CHECK SRS WARNING LIGHT

   1. Check the SRS warning light (Click here).