REAR DOOR BELT MOULDING(for Sedan) REMOVAL

CAUTION / NOTICE / HINT

Tip:
  • Use the same procedure for the RH and LH sides.

  • The procedure described below is for the LH side.

PROCEDURE

  1. PRECAUTION (w/ Power Window)

    Note:

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

    Click hereClick hereClick here

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL (w/ Power Window)

    Note:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click hereClick hereClick hereClick hereClick here

  3. REMOVE REAR ARMREST ASSEMBLY

  4. REMOVE REAR DOOR WINDOW REGULATOR HANDLE ASSEMBLY (w/o Power Window)

  5. REMOVE REAR DOOR ARMREST UPPER BASE PANEL (w/o Power Window)

  6. REMOVE REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR ARMREST BASE PANEL (w/ Power Window)

  7. REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY

  8. REMOVE REAR DOOR INNER GLASS WEATHERSTRIP

  9. REMOVE REAR DOOR SERVICE HOLE COVER

  10. DISCONNECT REAR DOOR WEATHERSTRIP

    1. B352655

      Using a clip remover, disengage the clip and disconnect the rear door weatherstrip.

  11. REMOVE REAR DOOR GLASS RUN

  12. REMOVE REAR DOOR LOWER WINDOW FRAME SUB-ASSEMBLY

  13. REMOVE REAR DOOR QUARTER WINDOW GLASS

  14. REMOVE REAR DOOR GLASS SUB-ASSEMBLY

  15. REMOVE REAR DOOR BELT MOULDING ASSEMBLY

    1. for Resin Type:

      1. B350919C01

        *a

        Protective Tape

        V100155

        Protective Tape

        Put protective tape around the rear door belt moulding assembly.

      2. Using a screwdriver with its tip wrapped with protective tape, disengage the 6 claws (A) as shown in the illustration.

        Tip:

        Tape the screwdriver tip before use.

      3. Disengage the 2 claws (B) to remove the rear door belt moulding assembly.

    2. for Plating Type:

      1. B350921C01

        *a

        Protective Tape

        V100155

        Protective Tape

        Put protective tape around the rear door belt moulding assembly.

      2. Using a screwdriver with its tip wrapped with protective tape, disengage the 6 claws (A) as shown in the illustration.

        Tip:

        Tape the screwdriver tip before use.

      3. Disengage the claw (B) and guide to remove the rear door belt moulding assembly.