PATTERN SELECT SWITCH INSPECTION

PROCEDURE

  1. INSPECT COMBINATION SWITCH ASSEMBLY

    1. C277027C03

      *a

      Component without harness connected

      (Combination Switch Assembly)

      w/o Stop and Start System:

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance

      Tester Connection

      Switch Condition

      Specified Condition

      2 (MSW1) - 4 (MSW2)

      Combination switch (SPORT) on

      Below 1 Ω

      2 (MSW1) - 4 (MSW2)

      Combination switch (SPORT) off

      10 kΩ or higher

      If the result is not as specified, replace the combination switch assembly.

    2. C341835C01

      *a

      Component without harness connected

      (Combination Switch Assembly)

      w/ Stop and Start System:

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance

      Tester Connection

      Switch Condition

      Specified Condition

      2 (MSW1) - 5 (MSW2)

      Combination switch (POWER MODE) on

      Below 1 Ω

      2 (MSW1) - 5 (MSW2)

      Combination switch (POWER MODE) off

      10 kΩ or higher

      If the result is not as specified, replace the combination switch assembly.