ECD SYSTEM, Diagnostic DTC:P1439

DTC Code DTC Name
P1439 Incomplete Regeneration of Particulate Filter

DESCRIPTION

Tip:

For more information on the diesel particulate filter (DPF) catalyst regeneration control, refer to System Description.

Click here

DTC No.

Detection Item

DTC Detection Condition

Trouble Area

MIL

Memory

P1439

Incomplete Regeneration of Particulate Filter

Measured amount of soot exceeds threshold.

(3 trip detection logic)

  • Exhaust manifold converter sub-assembly (DPF catalytic converter)

  • ECM

Does not come on

DTC stored
Table 1. Related Data List

DTC No.

Data List

P1439

Adaptation Value of Differential Pressure at Particle Filter

CAUTION / NOTICE / HINT

Note:

  • When replacing the ECM, the ECM needs registration and initialization.

    Click here

  • After replacing the DPF catalyst, the ECM needs initialization.

    Click here

Tip:

  • When the ECM must be replaced, before replacing the ECM, perform the "Learning Values Save" function using the GTS. Then after installing the new ECM, perform all of the initialization/registrations for the "Learning Values Write" function by following the instructions shown on the GTS display.

  • Read freeze frame data using the GTS. Freeze frame data records the engine condition when malfunctions are detected. When troubleshooting, freeze frame data can help determine if the vehicle was moving or stationary, if the engine was warmed up or not, and other data from the time the malfunction occurred.

PROCEDURE

  1. REPLACE EXHAUST MANIFOLD CONVERTER SUB-ASSEMBLY (DPF CATALYTIC CONVERTER)

    1. Replace the exhaust manifold converter sub-assembly.

      Click here

    2. Perform DPF history information reset and NOx storage catalyst learning value reset.

      Click here

    Result

    Proceed to

    NEXT
    NEXT

  2. CHECK WHETHER DTC OUTPUT RECURS

    1. Connect the GTS to the DLC3.

    2. Turn the ignition switch to ON and turn the GTS on.

    3. Clear the DTCs.

      Powertrain > Engine and ECT > Clear DTCs

    4. Turn the ignition switch off and wait for 60 seconds or more [A].

    5. Perform road test [B].

    6. Repeat [A] and [B] for the number of trips detected.

    7. Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.

      Powertrain > Engine and ECT > Trouble Codes

    8. Read the DTCs.

      Result

      Result

      Result

      Proceed to

      No DTC output

      No DTC output

      A

      DTC P1439

      DTC P1439

      B
    A

    END

    B

  3. REPLACE ECM

    1. Replace the ECM.

      Click here

    Result

    Proceed to

    NEXT
    NEXT

  4. CONFIRM WHETHER MALFUNCTION HAS BEEN SUCCESSFULLY REPAIRED

    1. Connect the GTS to the DLC3.

    2. Turn the ignition switch to ON and turn the GTS on.

    3. Clear the DTCs.

      Powertrain > Engine and ECT > Clear DTCs

    4. Turn the ignition switch off and wait for 60 seconds or more [A].

    5. Perform road test [B].

    6. Repeat [A] and [B] for the number of trips detected.

    7. Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.

      Powertrain > Engine and ECT > Trouble Codes

    8. Confirm that the DTC is not output again.

    Result

    Proceed to

    NEXT
    NEXT

    END