REAR DOOR BELT MOULDING(for Sedan) INSTALLATION

CAUTION / NOTICE / HINT

Tip:

  • Use the same procedure for the RH and LH sides.

  • The procedure described below is for the LH side.

PROCEDURE

  1. INSTALL REAR DOOR BELT MOULDING ASSEMBLY

    1. for Resin Type:

      1. B350920

        Engage the 8 claws to install the rear door belt moulding assembly.

    2. for Plating Type:

      1. B350922

        Engage the guide and 7 claws to install the rear door belt moulding assembly.

  2. INSTALL REAR DOOR GLASS SUB-ASSEMBLY

    Click here

  3. INSTALL REAR DOOR QUARTER WINDOW GLASS

    Click here

  4. INSTALL REAR DOOR LOWER WINDOW FRAME SUB-ASSEMBLY

    Click here

  5. INSTALL REAR DOOR GLASS RUN

    Click here

  6. CONNECT REAR DOOR WEATHERSTRIP

    1. Engage the clip and connect the rear door weatherstrip.

  7. INSTALL REAR DOOR SERVICE HOLE COVER

    Click here

  8. INSTALL REAR DOOR INNER GLASS WEATHERSTRIP

    Click here

  9. INSTALL REAR DOOR TRIM BOARD SUB-ASSEMBLY

    Click here

  10. INSTALL REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR ARMREST BASE PANEL (w/ Power Window)

    Click here

  11. INSTALL REAR DOOR ARMREST UPPER BASE PANEL (w/o Power Window)

    Click here

  12. INSTALL REAR DOOR WINDOW REGULATOR HANDLE ASSEMBLY (w/o Power Window)

    Click here

  13. INSTALL REAR ARMREST ASSEMBLY

    Click here

  14. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL (w/ Power Window)

    Note:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click hereClick hereClick hereClick here

  15. INITIALIZE POWER WINDOW CONTROL SYSTEM (w/ Power Window)

    Click here

  16. INSPECT POWER WINDOW OPERATION (w/ Power Window)

    Click here