FRONT WIPER MOTOR INSTALLATION


  1. INSTALL WINDSHIELD WIPER MOTOR ASSEMBLY

    A01DXYV

    1. Using a T30 ''torx'' socket, install the wiper motor with the 2 bolts.

      Torque:
      7.5 N*m  { 76 kgf*cm, 66 in.*lbf }

    2. Apply MP grease to the sliding parts of the wiper motor and the 2 rods of the wiper link.

    3. Connect the 2 rods of the wiper link to the wiper motor.

  2. INSTALL WINDSHIELD WIPER MOTOR & LINK ASSEMBLY

    A01E0EW

    1. Move the wiper motor & link in the direction shown by the arrow in the illustration to attach the wiper cushion to the body, and install the wiper motor & link.

    2. Install the 2 bolts.

      Torque:
      5.5 N*m  { 56 kgf*cm, 49 in.*lbf }

    3. Connect the connector.

  3. INSTALL COWL TOP VENTILATOR LOUVER LH

    A01E2WFE03

    1. Attach the 5 claws and install the louver.

  4. INSTALL COWL TOP VENTILATOR LOUVER RH

    A01DW9VE03

    1. Attach the 4 claws and install the louver.

  5. INSTALL HOOD TO COWL TOP SEAL

    A01E12HE03

    1. Attach the 9 clips and install the seal.

  6. INSTALL FRONT WIPER ARM & BLADE ASSEMBLY RH


    1. A01E1WUE07

      Stop the wiper motor at the automatic stop position.

    2. Clean the wiper arm serration with a round file or equivalent.

    3. Clean the wiper pivot serration with a wire brush.

    4. A01DVAAE01

      Install the arm & blade with the nut. Make sure that the arm & blade comes to the position shown in the illustration.

      Torque:
      19.6 N*m  { 200 kgf*cm, 14 ft.*lbf }

      Tech Tips

      Hold down the arm hinge with your hand while tightening the nut.

  7. INSTALL FRONT WIPER ARM & BLADE ASSEMBLY LH


    1. A01E1WUE07

      Clean the wiper arm serration with a round file or equivalent.

    2. Clean the wiper pivot serration with a wire brush.

    3. A01DY0CE01

      Install the arm & blade with the nut. Make sure that the arm & blade comes to the position shown in the illustration.

      Torque:
      19.6 N*m  { 200 kgf*cm, 14 ft.*lbf }

      Tech Tips

      Hold down the arm hinge with your hand while tightening the nut.

    4. Operate the front wipers while spraying water or washer fluid on the windshield. Ensure that there is no interference between the blades and pillar.

  8. INSTALL FRONT WIPER ARM HEAD CAP


    1. Install the 2 caps.

  9. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

  10. PERFORM INITIALIZATION


    1. Perform initialization Click here.

      Note

      Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.