| DTC Code | DTC Name |
|---|---|
| C1783 | Speed Signal Communication Error |
DESCRIPTION
The speed sensors monitor the speed of the wheels and send an appropriate speed signal to the absorber control ECU (rear acceleration sensor) through the skid control ECU (brake actuator assembly).
If a malfunction occurs in either a front speed sensor or rear speed sensor, DTC C1783 is stored.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | Warning Indicate | Note |
|---|---|---|---|---|---|
| C1783 | Speed Signal Communication Error | A speed sensor malfunction signal from the skid control ECU (brake actuator assembly) is detected for 1 second or more. |
|
Does not come on | - |
CAUTION / NOTICE / HINT
Note
Before performing troubleshooting, inspect the connectors of related circuits.
If DTC C1782 (Power Source Voltage Malfunction) is output at the same time, perform troubleshooting for C1782 first.
Before replacing the absorber control ECU (rear acceleration sensor), perform all of the following:
Symptom simulation.
DTC inspection.
GTS inspection.
If no malfunctions are found in other areas, replace the absorber control ECU (rear acceleration sensor).
When the absorber control ECU (rear acceleration sensor) is replaced, switch to test mode and check that all test mode DTCs are cleared when their respective deletion conditions are met.
PROCEDURE
CHECK FOR DTC (CAN COMMUNICATION SYSTEM)
Check for DTCs.
| Result | ||||||
|---|---|---|---|---|---|---|
|
| B |
|
GO TO CAN COMMUNICATION SYSTEM (HOW TO PROCEED WITH TROUBLESHOOTING) Click here |
| A |
|
CHECK FOR DTC (VEHICLE STABILITY CONTROL SYSTEM)
Check if DTC C1783 and a vehicle stability control system speed sensor malfunction DTC are output.
| Result | ||||||
|---|---|---|---|---|---|---|
|
| A |
|
REPLACE ABSORBER CONTROL ECU (REAR ACCELERATION SENSOR) Click here |
| B |
|
GO TO VEHICLE STABILITY CONTROL SYSTEM (DIAGNOSTIC TROUBLE CODE CHART) Click here |