OCCUPANT CLASSIFICATION ECU INSTALLATION

PROCEDURE


  1. INSTALL OCCUPANT DETECTION ECU


    1. Insert the occupant detection ECU as shown in the illustration.

      Note

      If the occupant detection ECU has been dropped, or there are any cracks, dents or other defects in the case or connector, replace the occupant detection ECU with a new one.

      B006D8C
    2. B0069KWC01
      B006DHE Install in this Direction

      Attach the claw to install the occupant detection ECU.

      Note

      When installing the occupant detection ECU, make sure that the SRS wiring does not interfere with or is pinched between other parts.

    3. B006CEN

      Connect the 2 connectors.

    4. B006B84

      w/ Rear Seat Entertainment System:


      1. Attach the 2 claws to connect the 2 connectors.

      2. Attach the wire harness clamp.

  2. INSTALL FRONT SEAT ASSEMBLY RH

    Tech Tips

    Use the same procedure as for the LH side.

    Click here

  3. PERFORM ZERO POINT CALIBRATION AND SENSITIVITY CHECK

    Click here

  4. PERFORM DIAGNOSTIC SYSTEM CHECK

    for Occupant Classification System:

    Click here

    for SRS System:

    Click here

  5. CHECK SRS WARNING LIGHT

    Click here

  6. PERFORM SYSTEM CALIBRATION

    Click here