GENERATOR REMOVAL

PROCEDURE

  1. PRECAUTION

    Note:

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work.

    Click hereClick hereClick here

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click hereClick hereClick hereClick here

  3. REMOVE NO. 1 ENGINE COVER

    Click hereClick hereClick here

  4. REMOVE FAN AND GENERATOR V BELT

    Click here

  5. REMOVE FRONT DRIVE SHAFT ASSEMBLY RH

    Click here

  6. REMOVE WIRE HARNESS CLAMP BRACKET

    1. A297139

      Disconnect the sensor connector and detach the wire harness clamp.

    2. Remove the bolt and wire harness clamp bracket.

  7. REMOVE GENERATOR ASSEMBLY

    1. A297140

      Remove the bolt and disconnect the wire harness bracket from the generator assembly.

    2. Remove the terminal cap.

    3. Remove the nut and disconnect the wire harness from terminal B.

    4. Disconnect the connector from the generator assembly.

    5. A297141

      Remove the 3 bolts and generator assembly.