TIRE AND WHEEL SYSTEM INSPECTION

PROCEDURE


  1. INSPECT TIRES


    1. Check the tires for wear and proper inflation pressure.

      Cold Tire Inflation Pressure
      Tire Size

      Front

      kPa (kgf/cm2, psi)

      Rear

      kPa (kgf/cm2, psi)
      205/60R16 92V

      250 (2.5, 36)

      240 (2.4, 35)*1

      250 (2.5, 36)

      230 (2.3, 33)*1
      215/50R17 91V 230 (2.3, 33) 230 (2.3, 33)

      *1: for Australia

    2. A005AOQ

      Using a dial indicator, check the runout of the tires.

      Maximum Tire Runout
      1.4 mm (0.0551 in.)

  2. ROTATE TIRES


    1. A005DD8

      Rotate the tires as shown in the illustration.

      Text in Illustration
      A005EL2 Front

  3. INSPECT AND ADJUST WHEEL BALANCE


    1. A005AWUE08

      Inspect and adjust the off-the-car balance.

      Maximum Imbalance
      8.0 g (0.0176 lb)

      Note


      • Use a cleaning detergent to remove dirt, oil and water from the surface where the balance weight is to be adhered.

      • Do not touch the adhesive surface of the balance weight.

      • Adhere a stick-on type balance weight to the flat surface (A) shown in the illustration.

        Width (A)
        25 mm (0.984 in.)

      • Push the balance weight securely with your finger to adhere it to the desired position.

      • Do not reuse balance weights.

      Tech Tips

      The inner side balance weight should be installed by clipping it to the rim.

  4. INSPECT FRONT AXLE HUB AND BEARING

    Click here

  5. INSPECT REAR AXLE HUB AND BEARING

    Click here