REAR DOOR BELT MOULDING INSTALLATION

CAUTION / NOTICE / HINT

Tip:

  • Use the same procedure for the RH side and LH side.

  • The procedure listed below is for the LH side.

  • A bolt without a torque specification is shown in the standard bolt chart (Click here).

PROCEDURE

  1. INSTALL REAR DOOR BELT MOULDING ASSEMBLY LH

    B221150

    1. Attach the 8 claws to install the rear door belt moulding.

  2. INSTALL REAR DOOR GLASS SUB-ASSEMBLY LH

    Click here

  3. INSTALL REAR DOOR QUARTER WINDOW GLASS LH

    Click here

  4. INSTALL REAR DOOR WINDOW DIVISION BAR SUB-ASSEMBLY LH

    Click here

  5. INSTALL REAR DOOR GLASS RUN LH

    Click here

  6. INSTALL REAR DOOR SERVICE HOLE COVER LH

    Click here

  7. INSTALL REAR DOOR INNER GLASS WEATHERSTRIP LH

    Click here

  8. INSTALL REAR DOOR INSIDE HANDLE SUB-ASSEMBLY LH

    Click here

  9. INSTALL REAR DOOR TRIM BOARD SUB-ASSEMBLY LH

    Click here

  10. INSTALL REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR ARMREST BASE PANEL (w/ Power Window)

    Click here

  11. INSTALL REAR DOOR TRIM MOULDING LH

    Click here

  12. INSTALL REAR DOOR INSIDE HANDLE BEZEL LH

    Click here

  13. INSTALL REAR DOOR REGULATOR INSIDE HANDLE PLATE (w/o Power Window)

    Click here

  14. INSTALL REAR DOOR WINDOW REGULATOR HANDLE ASSEMBLY (w/o Power Window)

    Click here

  15. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).