ДАТЧИК ТЕМПЕРАТУРЫ ОТРАБОТАВШИХ ГАЗОВ (передний) СНЯТИЕ


  1. REMOVE SEAT TRACK COVER LH


    1. B007Q5Y

      С помощью съемника фиксаторов освободите фиксатор.

    2. Расцепите захват и снимите щиток направляющей левого сиденья.

  2. REMOVE FRONT SEAT ASSEMBLY RH


    1. B007OW8

      Выдвиньте переднее сиденье в сборе до упора вперед.

    2. Выверните 2 болта с задней стороны сиденья.

    3. Сдвиньте переднее сиденье в сборе в крайнее заднее положение.

    4. Выверните 2 болта с передней стороны сиденья.

    5. Сдвиньте переднее сиденье в сборе к середине направляющей сиденья. Установите спинку сиденья в вертикальное положение.

    6. Отсоедините разъем замка ремня безопасности переднего сиденья.

    7. Снимите переднее сиденье в сборе.

  3. REMOVE FRONT DOOR SCUFF PLATE RH

  4. REMOVE ENGINE SERVICE HOLE SUB COVER SUB-ASSEMBLY


    1. Fold back the floor carpet.

    2. Remove the 5 bolts and engine service hole sub cover sub-assembly.

  5. REMOVE ENGINE ASSEMBLY

    Tech Tips

    Perform this procedure only when removal or installation of the No. 3 exhaust gas temperature sensor.

    Click here

  6. REMOVE EXHAUST GAS TEMPERATURE SENSOR

    CAUTION:

    To prevent burns, do not touch the engine, exhaust manifold or other high temperature components while the engine is hot.


    1. B007OTM

      Disconnect the 3 connectors from the 3 exhaust gas temperature sensors.

    2. B007R5C

      Remove the nut and disconnect the No. 3 exhaust gas temperature sensor from the No. 1 vacuum pipe.

    3. B007RWD

      Remove the bolt and open the clamp of the pipe clamp.

    4. Detach the 3 connectors from the pipe clamp.

    5. B007REK

      Using a 14 mm union nut wrench, remove the exhaust gas temperature sensor from the exhaust manifold converter sub-assembly.

    6. B007QVF

      Using a 14 mm union nut wrench, remove the No. 2 exhaust gas temperature sensor from the exhaust manifold converter sub-assembly.

    7. B007SY8

      Using a 14 mm union nut wrench, remove the No. 3 exhaust gas temperature sensor from the exhaust manifold converter sub-assembly.