HOOD LOCK CONTROL CABLE ASSEMBLY INSTALLATION

CAUTION / NOTICE / HINT

PROCEDURE

1. INSTALL HOOD LOCK CONTROL CABLE ASSEMBLY (for LHD)

   
   

   1. Pass the hood lock control cable assembly into the engine compartment.

   2. Engage the grommet.

      

      *a

      Grommet

      -

      -

   3. Connect the hood lock control cable assembly to the clamps.

2. INSTALL HOOD LOCK CONTROL CABLE ASSEMBLY (for RHD)

   
   

   1. Pass the hood lock control cable assembly into the engine compartment.

   2. Engage the grommet.

      

      *a

      Grommet

      -

      -

   3. Connect the hood lock control cable assembly to the clamps.

3. INSTALL HOOD LOCK CONTROL LEVER SUB-ASSEMBLY

   
   

   1. Install the hood lock control lever sub-assembly to the hood lock control cable assembly.

4. INSTALL HOOD LOCK CONTROL CABLE HOLDER

   
   

   1. 

      Install in this Direction

      Engage the claw to install the hood lock control cable holder as shown in the illustration.

5. CONNECT HOOD LOCK CONTROL LEVER SUB-ASSEMBLY

   Click here

6. INSTALL HOOD LOCK ASSEMBLY (w/o Engine Hood Courtesy Switch)

   
   

   1. Apply MP grease to the sliding areas of the hood lock assembly.

   2. Connect the hood lock control cable assembly to the hood lock assembly.

   3. Install the hood lock assembly with the 2 bolts and hood lock bolt.

      Torque:

      7.5 N*m  { 76 kgf*cm, 66 in.*lbf }

7. INSTALL HOOD LOCK ASSEMBLY (w/ Engine Hood Courtesy Switch)

   Click here

8. INSTALL HOOD LOCK NUT CAP

   Click here

9. INSTALL NO. 1 RADIATOR TO SUPPORT SEAL

   Click here

10. INSTALL NO. 1 RADIATOR GRILLE RETAINER

    Click here

11. INSTALL FRONT FENDER LINER LH

    Tech Tips

    Use the same procedure as for the RH side.

    Click here

12. INSTALL BODY ROCKER PANEL MOULDING ASSEMBLY

    Click here

13. INSTALL FRONT FENDER MOULDING SUB-ASSEMBLY

    Click here

14. INSTALL FRONT BUMPER ASSEMBLY

    Click here

15. INSTALL FRONT WHEEL

    Click here

16. ADJUST HOOD SUB-ASSEMBLY

    Click here