ROOF SUNSHADE REASSEMBLY

PROCEDURE


  1. INSTALL SLIDING ROOF DRIVE CABLE RH


    1. A01HIP5

      Install the sliding roof drive cable RH to the sunshade housing assembly.

  2. INSTALL SLIDING ROOF DRIVE CABLE LH


    1. A01HIEN

      Install the sliding roof drive cable LH to the sunshade housing assembly.

  3. INSTALL SUNSHADE TRIM SUB-ASSEMBLY


    1. A01HHBU

      Install the sliding roof drive cable to the sunshade trim sub-assembly.

    2. A01HI67

      Install the sunshade trim sub-assembly to the sunshade housing assembly.

    3. A01HGKS

      Install the sliding housing center frame with the 4 screws.

      Torque:
      2.0 N*m  { 20 kgf*cm, 18 in.*lbf }

  4. ADJUST FULLY CLOSED POSITION


    1. A01HHPVC01
      *a Alignment Mark

      Slide the sunshade trim sub-assembly so that it is aligned with the alignment marks.

      Standard
      Area Measurement
      a 3.0 mm (0.1181 in.)

      Tech Tips

      Make sure that the difference between the alignment mark position on the left and right of the sunshade trim sub-assembly is within 3.0 mm (0.1181 in.).

  5. TEMPORARILY TIGHTEN SLIDING ROOF DRIVE GEAR SUB-ASSEMBLY


    1. Apply MP grease around the gear of the sliding roof drive gear sub-assembly.

    2. A01HFBY

      Temporarily install the sliding roof drive gear assembly to the sliding roof housing sub-assembly with the bolt.

  6. INSTALL ROOM LIGHT BRACKET


    1. A01HEIE

      Install the room light bracket with the bolt.

  7. TIGHTEN SLIDING ROOF DRIVE GEAR SUB-ASSEMBLY


    1. A01HEFL

      Tighten the 2 bolts to install the sliding roof drive gear assembly.

      Torque:
      5.4 N*m  { 55 kgf*cm, 48 in.*lbf }