REAR CRANKSHAFT OIL SEAL INSTALLATION

PROCEDURE

  1. INSTALL REAR ENGINE OIL SEAL

    1. Apply MP grease to the lip of a new rear engine oil seal.

    2. A202329N02

      Using SST and a hammer, tap in the rear engine oil seal as shown in the illustration.

      09223-56010

      Standard depth

      0 to 0.9 mm (0 to 0.0354 in.)

      Note:

      • Keep the lip free from foreign matter.

      • Do not tap the rear engine oil seal at an angle.

      • Make sure that the rear engine oil seal is properly installed.

  2. INSTALL DRIVE PLATE AND RING GEAR SUB-ASSEMBLY

    Click hereClick here

  3. INSTALL AUTOMATIC TRANSAXLE ASSEMBLY

    Click here

  4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click hereClick hereClick hereClick hereClick hereClick here