WHEN REMOVING,INSTALLING OR REPLACING PARTS WHEEL ALIGNMENT STANDARD

MEASURE VEHICLE HEIGHT

Note

Before inspecting the wheel alignment, adjust the vehicle height to the specification.
1. Press down on the vehicle several times to stabilize the suspension, and measure the vehicle height.
  1. *A for Front
    
    *B for Rear
    
    for 2WD:
    
    If the vehicle height is not as specified, adjust the height by pressing down on the vehicle several times to stabilize the suspension.
    
    Note
    
    The standard value shown above is a value that is used for adjusting the wheel alignment and does not indicate the height of an actual vehicle.
    
    *A for Front
    
    *B for Rear

for 4WD and Pre-Runner:

If the vehicle height is not as specified, adjust the height by pressing down on the vehicle several times to stabilize the suspension.

Note

The standard value shown above is a value that is used for adjusting the wheel alignment and does not indicate the height of an actual vehicle.

INSPECT CAMBER, CASTER AND STEERING AXIS INCLINATION

*a	Alignment Tester
*b	Gauge

Install a camber-caster-kingpin gauge or place the front wheels on the center of a wheel alignment tester.

Inspect the camber, caster and steering axis inclination

If the camber and caster are not as specified, adjust them.

If the steering axis inclination is not as specified after the camber and caster have been correctly adjusted, check the steering knuckle and front wheel for distortion or looseness.

INSPECT TOE-IN

A01SF2VC06

A01SF37

Front of the Vehicle

If the toe-in is not as specified, adjust it at the rack ends.

INSPECT WHEEL ANGLE

*a	Inside
*b	Outside
	Front of the Vehicle

Turn the steering wheel to the left and right full lock positions, and measure the wheel angle.

If the angles are not as specified, check and adjust the right and left rack end lengths.