CRUISE CONTROL SYSTEM Cruise Main Indicator Light Circuit

DESCRIPTION

• The power management control ECU turns on the cruise control indicator light by sending indicator output demand signals to the combination meter sub-assembly using CAN communication.

• The cruise control indicator light illuminates in green when the cruise control system has been turned on using the ON-OFF switch. If a malfunction is detected, the cruise control indicator light changes to amber (w/o multi-information display), or the cruise control indicator light goes out and a warning message is displayed (w/ multi-information display).

• The cruise control indicator light circuit uses CAN communication. If the cruise control indicator light is not functioning correctly, check for CAN communication DTCs before troubleshooting this circuit.

WIRING DIAGRAM

PROCEDURE

1. PERFORM ACTIVE TEST USING GTS

   
   

   1. Connect the GTS to the DLC3.

   2. Turn the power switch on (IG).

   3. Turn the GTS on.

   4. Select the following menu items: Body Electrical / Combination Meter / Active Test.

   5. Check the cruise control indicator light by performing the Active Test.

      Combination Meter

      Tester Display	Test Part	Control Range	Diagnostic Note
      Indicat. Lamp Cruise	Cruise control indicator light	Cruise control indicator light (illuminated in green) ON / OFF	-
      Cruise Indicator	Cruise control indicator light	Cruise control indicator light (illuminated in amber) ON / OFF	w/o multi-information display

      OK
      The cruise control indicator light goes on or off.

      Result

      Result	Proceed to
      OK	A
      NG (w/ Multi-information Display)	B
      NG (w/o Multi-information Display)	C

   
   

   A

   PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE Click here

   B

   REPLACE COMBINATION METER SUB-ASSEMBLY Click here

   C

   REPLACE METER CIRCUIT PLATE Click here