OUTER REAR VIEW MIRROR DISASSEMBLY

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH side and LH side.

  • The following procedure is for the LH side.

PROCEDURE


  1. REMOVE OUTER MIRROR

    Click here

  2. REMOVE NO. 1 OUTER MIRROR COVER

    Click here

  3. REMOVE NO. 2 OUTER MIRROR COVER


    1. A01RBTT

      Remove the screw.

    2. Disengage the 5 claws and guide to remove the No. 2 outer mirror cover.

  4. REMOVE OUTER MIRROR HOLE COVER


    1. w/ Panoramic View Monitor System:


      1. A01R936

        Disengage the clamp.

      2. A01RAR4C01
        *a Claw
        *b Protrusion
        *c Insert Position

        Insert a 0.9 mm (0.0354 in.) spark plug gap gauge or similar tool into the connector as shown in the illustration. Lift the claw and disconnect the connector.

        Note


        • Insert the spark plug gap gauge to the point that the claw becomes the same height as the protrusion of the connector housing. If the spark plug gap gauge is inserted too far, or if the claw is lifted directly using a screwdriver, the claw may be damaged.

        • If the claw on the connector is damaged, replace the outer rear view mirror assembly.

    2. A01RDX6

      Remove the screw.

    3. Disengage the 3 claws and 2 guides to remove the outer mirror hole cover.

  5. REMOVE SIDE TURN SIGNAL LIGHT ASSEMBLY

    Click here