REAR DOOR SPEAKER REMOVAL

CAUTION / NOTICE / HINT

Tip:

  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.

PROCEDURE

  1. PRECAUTION

    Note:

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work. (Click here).

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).

  3. REMOVE REAR DOOR WINDOW REGULATOR HANDLE ASSEMBLY (w/o Power Window)

    Click here

  4. REMOVE REAR DOOR REGULATOR INSIDE HANDLE PLATE (w/o Power Window)

    Click here

  5. REMOVE REAR DOOR INSIDE HANDLE BEZEL LH

    Click here

  6. REMOVE REAR DOOR TRIM MOULDING LH

    Click here

  7. REMOVE REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR ARMREST BASE PANEL (w/ Power Window)

    Click here

  8. REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY LH

    Click here

  9. REMOVE REAR DOOR INSIDE HANDLE SUB-ASSEMBLY LH

    Click here

  10. REMOVE REAR SPEAKER ASSEMBLY

    Note:

    Do not touch the cone part of the speaker.

    1. Disconnect the speaker connector.

    2. B222511

      Using a drill bit with a diameter of less than 4 mm (0.157 in.), drill out the 3 rivet heads.

      CAUTION:

      Be careful as the cut rivet will be very hot.

      Note:

      Do not drill the rivet at an angle as this will cause damage to the drill and drill hole. Line up the drill and rivet, and carefully drill out the rivet head.

    3. Continue drilling and push out the remaining rivet fragments.

    4. Using a vacuum cleaner, remove the rivet fragments and shavings from the inside of the door.

    5. Detach the claw and remove the speaker.