CENTER AIRBAG SENSOR ASSEMBLY REMOVAL

PROCEDURE

1. PRECAUTION

   CAUTION:

   Be sure to read Precaution thoroughly before servicing.

   Click here

   Note:

   After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

   Click hereClick hereClick here

2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

   CAUTION:

   Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

   Note:

   When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

   Click hereClick hereClick hereClick hereClick here

3. REMOVE FRONT NO. 1 CONSOLE BOX INSERT

   for Hatchback, Wagon:Click hereClick here

   for Sedan:Click hereClick here

4. REMOVE FRONT NO. 2 CONSOLE BOX INSERT

   for Hatchback, Wagon:Click hereClick here

   for Sedan:Click hereClick here

5. REMOVE AIRBAG SENSOR ASSEMBLY

   1. Check that the ignition switch is off.

   2. Check that the cable is disconnected from the negative (-) battery terminal.

      CAUTION:

      Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

   3. Turn back the carpet.

   4. 

      Disconnect the connectors from the airbag sensor assembly as shown in the illustration.

      Note:

      When disconnecting any airbag connector, take care not to damage the airbag wire harness.

   5. 

      Remove the 3 bolts and airbag sensor assembly.