CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during front seat airbag assembly removal/installation are shown below.
Replaced Part or Performed Procedure | Necessary Procedure | Effect/Inoperative Function when Necessary Procedure not Performed | Link |
---|---|---|---|
Removal/installation of the front passenger seat*1 | Zero point calibration (Occupant classification system) |
|
|
Disconnect cable from negative battery terminal | Perform steering sensor zero point calibration | Lane departure alert system (w/ Steering Control) | |
Pre-collision system | |||
Memorize steering angle neutral point | Parking assist monitor system | ||
Panoramic View Monitor System |
CAUTION:
Be sure to read Precaution thoroughly before servicing.
Wear protective gloves. Sharp areas on the parts may injure your hands.
Note
If a front seat airbag assembly has been deployed, replace the front seat airbag assembly, front seatback frame sub-assembly, separate type front seatback pad and separate type front seatback cover with the necessary parts in accordance with the extent of the collision damage.
for Manual Seat: Click here
for Power Seat: Click here
PROCEDURE
REMOVE FRONT SEAT ASSEMBLY (for Power Seat)
REMOVE FRONT SEAT ASSEMBLY (for Manual Seat)
DISCONNECT SEPARATE TYPE FRONT SEATBACK COVER (for Power Seat)
DISCONNECT SEPARATE TYPE FRONT SEATBACK COVER (for Manual Seat)
REMOVE VERTICAL ADJUSTING HANDLE (for Manual Seat with Vertical Adjuster)
REMOVE RECLINING HINGE COVER (for Manual Seat)
REMOVE RECLINING ADJUSTER RELEASE HANDLE (for Manual Seat)
REMOVE SEAT ADJUSTER COVER CAP (for Manual Seat with Vertical Adjuster)
REMOVE FRONT SEAT FRONT CUSHION SHIELD (for Power Seat)
REMOVE FRONT SEAT CUSHION SHIELD (for Power Seat)
w/o Vertical Adjuster: Click here
w/ Vertical Adjuster: Click here
REMOVE FRONT SEAT CUSHION SHIELD (for Manual Seat)
w/o Vertical Adjuster: Click here
w/ Vertical Adjuster: Click here
REMOVE FRONT SEAT INNER CUSHION SHIELD (for Power Seat)
w/o Vertical Adjuster: Click here
w/ Vertical Adjuster: Click here
REMOVE FRONT SEAT INNER CUSHION SHIELD (for Manual Seat)
w/o Vertical Adjuster: Click here
w/ Vertical Adjuster: Click here
REMOVE SEPARATE TYPE FRONT SEATBACK ASSEMBLY (for Power Seat)
REMOVE SEPARATE TYPE FRONT SEATBACK ASSEMBLY (for Manual Seat)
REMOVE FRONT SEAT HEADREST SUPPORT (for Power Seat)
REMOVE FRONT SEAT HEADREST SUPPORT (for Manual Seat)
REMOVE SEPARATE TYPE FRONT SEATBACK COVER WITH PAD (for Power Seat)
REMOVE SEPARATE TYPE FRONT SEATBACK COVER WITH PAD (for Manual Seat)
REMOVE FRONT SEAT AIRBAG ASSEMBLY
CAUTION:
When storing the front seat airbag assembly, keep the airbag deployment side facing upward.
Deployment Side |
for Type A:
Disengage the clamp.
Remove the 2 nuts and front seat airbag assembly.
Note
Do not reuse the nuts.
Make sure that the front seatback frame sub-assembly is not deformed. If it is deformed, replace it with a new one.
for Type B:
Disengage the clamp.
Remove the 2 nuts and front seat airbag assembly.
Note
Do not reuse the nuts.
Make sure that the front seatback frame sub-assembly is not deformed. If it is deformed, replace it with a new one.