CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are installed, removed or replaced during the instrument panel passenger airbag assembly removal/installation are shown below.
Replacement Part or Procedure | Necessary Procedures | Effects/Inoperative Functions when not Performed | Link |
---|---|---|---|
Disconnect cable from negative (-) battery terminal | Drive the vehicle until stop and start control is permitted (approximately 5 to 60 minutes) | Stop and start system | for 2AR-FE: for 2GR-FKS: |
Memorize steering angle neutral point | Panoramic view monitor system | ||
Initialize servo motor | Air conditioning system | ||
Reset slide door close position | Power slide door system | ||
Reset back door close position | Back door opener | ||
Initialize back door lock | Power door lock control system |
Tech Tips
Use the same procedure for RHD and LHD vehicles.
The procedures listed below are for LHD vehicles.
PROCEDURE
PRECAUTION
Note
After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.
DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
If the airbag deploys for any reason, it may cause a serious accident.
Note
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
REMOVE INSTRUMENT PANEL SUB-ASSEMBLY
for LHD:
for RHD:
REMOVE NO. 2 INSTRUMENT PANEL WIRE
Using a screwdriver, pull up and release the connector lock and disconnect the airbag connector.
Tech Tips
Tape the screwdriver tip before use.
*a | Connector Lock |
Protective Tape | |
Release in this Direction |
Detach the wire harness clamp and remove the No. 2 instrument panel wire.
Note
When disconnecting any airbag connector, take care not to damage the airbag wire harness.
REMOVE INSTRUMENT PANEL PASSENGER AIRBAG ASSEMBLY
CAUTION:
Deployment side |
When storing the instrument panel passenger airbag assembly, keep the airbag deployment side facing upward.
If the airbag deploys for any reason, it may cause a serious accident.
Disconnect in this Direction |
Detach the hook and disconnect the pad.
Remove the 2 screws.
Insert moulding remover B into the side of the airbag door facing the rear of the vehicle and bend moulding remover B to detach the hook.
Raise in this Direction |
Raise the instrument panel passenger airbag assembly in the direction indicated by the arrow shown in the illustration to detach the hook on the side of the airbag door facing the front of the vehicle and remove the instrument panel passenger airbag assembly.