PROCEDURE
INSTALL OCCUPANT DETECTION ECU
Insert the occupant detection ECU as shown in the illustration.
Note
If the occupant detection ECU has been dropped, or there are any cracks, dents or other defects in the case or connector, replace the occupant detection ECU with a new one.
Install in this Direction |
Attach the claw to install the occupant detection ECU.
Note
When installing the occupant detection ECU, make sure that the SRS wiring does not interfere with or is pinched between other parts.
Connect the 2 connectors.
w/ Rear Seat Entertainment System:
Attach the 2 claws to connect the 2 connectors.
Attach the wire harness clamp.
INSTALL FRONT SEAT ASSEMBLY RH
PERFORM ZERO POINT CALIBRATION AND SENSITIVITY CHECK
PERFORM DIAGNOSTIC SYSTEM CHECK
for Occupant Classification System:
for SRS System:
CHECK SRS WARNING LIGHT
PERFORM SYSTEM CALIBRATION