PROCEDURE
CHECK PROBLEM SYMPTOM (WARNING NOTIFICATION FUNCTION)
Check the problem symptom.
Check the problem symptom of the warning notification function.
Result | |||||||||
---|---|---|---|---|---|---|---|---|---|
|
Tech Tips
The warning notification function sends information to the G-BOOK center through communication.
Carefully confirm the conditions that caused the malfunction in order to determine if a temporary problem with the radio wave signal conditions caused the malfunction.
B |
GO TO STEP 5 Click here |
C |
GO TO STEP 8 Click here |
A |
INSPECT WARNING LIGHT
Check if the indicated warning light or message is listed in the following table.
Tech Tips
Only messages listed in the table are included in the G-BOOK warning notification function.
Warning Name |
---|
Engine warning |
Brake system warning |
VSC warning |
ABS warning |
ECB warning |
EPS warning |
Charging system warning |
Airbag warning |
PCS warning |
Pedestrian protection system warning |
Cruise warning |
Parking support alert system warning |
Drive start control warning |
Brake override system warning |
Entry and start system warning |
Automatic high beam warning |
LED headlight warning |
Adaptive high beam system warning |
Electronic shift lever system warning |
Tire pressure system warning |
Electric parking brake warning |
Auto hold warning |
BSM system warning |
Lane departure alert system warning |
Wiper and washer system warning |
Stop and start system warning |
Automatic rear flashing hazard lights warning |
RCTA warning |
Rear camera detection warning |
Sub battery system warning |
Engine oil level warning |
Brake fluid warning |
Engine oil pressure warning |
Tire pressure low warning |
Washer fluid level warning |
Engine oil maintenance warning |
High coolant temperature warning |
Result | ||||||
---|---|---|---|---|---|---|
|
B |
END |
A |
CHECK FOR SERVICE FLAG
Check for service flags.
Enter diagnostic mode.
Select "Service Information" on the "Service Menu" screen.
Select "G-BOOK Info for Contract" on the "Service Information" screen.
Check if the flag information indicates "1" as shown in the illustration.
Result | ||||||
---|---|---|---|---|---|---|
|
*a | Cells to be Checked |
B |
GO TO STEP 9 Click here |
A |
CHECK CONNECTION
Select G-BOOK.com and check that the G-BOOK.com screen is displayed.
Result | ||||||
---|---|---|---|---|---|---|
|
B |
GO TO PROBLEM SYMPTOMS TABLE (Emergency Call Service Function) Click here |
A |
CHECK METER WARNING LIGHT
Check if a warning light on the combination meter assembly comes on or a warning message on the multi-information display is displayed even when there is no problem.
OK |
---|
There are no problems with warning lights or warning messages. |
Tech Tips
The warning notification function of the telematics system uses the warning notification signals sent and received by the meter/gauge system. Therefore, if the meter/gauge system is not operating normally, the warning notification function will not operate normally.
Result | |||
---|---|---|---|
|
NG |
GO TO METER / GAUGE SYSTEM Click here |
OK |
CHECK CAN COMMUNICATION SYSTEM
Connect the GTS to the DLC3.
Turn the engine switch on (IG).
Turn the GTS on.
Enter the following menus: Bus Check.
Check that all ECUs and sensors that use CAN communication are connected.
Result | ||||||
---|---|---|---|---|---|---|
|
B |
GO TO CAN COMMUNICATION SYSTEM Click here |
A |
CHECK DTC OUTPUT
Connect the GTS to the DLC3.
Turn the engine switch on (IG).
Turn the GTS on.
Enter the following menus: Health Check.
Check for DTCs.
Result | |||||||
---|---|---|---|---|---|---|---|
|
B |
CHECK EACH ECU SYSTEM |
A |
CHECK NAVIGATION SYSTEM
Check if the navigation system is operating and functioning normally.
OK |
---|
The navigation system is normal. |
Result | |||
---|---|---|---|
|
NG |
GO TO NAVIGATION SYSTEM Click here |
OK |
RENEW DATA
Renew the data.
Perform "Download necessary data" again.
Result | ||||||
---|---|---|---|---|---|---|
|
A |
END |
B |
CONTACT G-BOOK SUPPORT CENTER |