CAUTION / NOTICE / HINT
Note
If the millimeter wave radar sensor assembly has been struck or dropped, replace the millimeter wave radar sensor assembly with a new one.
PROCEDURE
INSTALL MILLIMETER WAVE RADAR SENSOR ASSEMBLY
Note
If the front bumper assembly, radiator grill, millimeter wave radar sensor assembly or No. 1 millimeter wave radar sensor bracket has been replaced, check that the beam axis change mechanism is at the standard position (centered).
Set beam axis to the standard position.
Turn the bolt so that the beam axis change mechanism is positioned as shown in the illustration.
Specified Condition |
---|
Difference between (A) and (B) |
1 mm (0.0394 in.) or less |
Bolt | |
Screw |
Engage the 2 guides.
Tighten the 2 bolts and 2 screws on the millimeter wave radar sensor assembly.
Tech Tips
Tighten the bolts in the order shown in the illustration.
Connect the connector.
INSTALL COOL AIR INTAKE DUCT SEAL
INSTALL ENGINE ROOM SIDE COVER
ADJUST MILLIMETER WAVE RADAR SENSOR
When the millimeter wave radar sensor assembly or No. 1 millimeter wave radar sensor bracket is replaced with a new one, adjustment of the radar sensor beam axis must be performed.