PROCEDURE
PRECAUTION
Note
When replacing the radio receiver assembly or navigation ECU, always replace it with a new one. If a radio receiver assembly or navigation ECU which was installed to another vehicle is used, the following may occur:
A communication malfunction DTC may be stored.
The radio receiver assembly or navigation ECU may not operate normally.
After replacing the navigation ECU, if "New software is not compatible with the system. Contact your dealer." is displayed on the multi-display, update the software of the radio receiver assembly.
REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY
REMOVE INSTRUMENT PANEL FINISH PANEL END LH
REMOVE INSTRUMENT PANEL FINISH PANEL END RH
REMOVE FRONT PANEL GARNISH LH
REMOVE FRONT PANEL GARNISH RH
REMOVE CONSOLE PANEL SUB-ASSEMBLY
REMOVE RADIO RECEIVER ASSEMBLY WITH BRACKET
REMOVE NO. 1 NAVIGATION WIRE
Disconnect the 2 connectors to remove the No. 1 navigation wire.
REMOVE NO. 1 RADIO BRACKET
REMOVE NO. 2 RADIO BRACKET
REMOVE RADIO RECEIVER ASSEMBLY
REMOVE NAVIGATION ECU