CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed or replaced during the amplifier antenna removal/installation are shown below.
Replacement Part or Procedure | Necessary Procedures | Effects / Inoperative when not Performed | Link |
---|---|---|---|
Disconnect cable from negative auxiliary battery terminal | Memorize steering angle neutral point | LKA/LDA system (for Mono camera type) | for Stereo Camera type:Click here for Mono Camera type:Click here |
Lane control system (for Stereo camera type) | |||
Parking support brake system* | |||
Pre-collision system (for Mono camera type) | |||
Pre-collision system (for Stereo camera type) | |||
Adaptive high beam system | |||
|
|||
Variable gear ratio steering system | |||
Parking assist monitor system | |||
Panoramic view monitor system | |||
Initialize rear door sunshade system | Rear door sunshade system | ||
Initialize power trunk lid system | Power trunk lid system |
PROCEDURE
PRECAUTION
After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work.
REMOVE LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY
DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL
Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.
If the airbag deploys for any reason, it may cause a serious accident.
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
REMOVE REAR SEAT ASSEMBLY
for Fixed Seat Type:
for Power Seat:
REMOVE REAR DOOR SCUFF PLATE LH
REMOVE REAR DOOR SCUFF PLATE RH
REMOVE REAR SEAT SIDE GARNISH LH
REMOVE REAR SEAT SIDE GARNISH RH
REMOVE ROOF SIDE RAIL GARNISH ASSEMBLY LH
REMOVE ROOF SIDE RAIL GARNISH ASSEMBLY RH
REMOVE PACKAGE TRAY TRIM GARNISH LH
REMOVE PACKAGE TRAY TRIM GARNISH RH
REMOVE PACKAGE TRAY TRIM SIDE COVER LH
REMOVE PACKAGE TRAY TRIM SIDE COVER RH
REMOVE INNER ROOF SIDE GARNISH ASSEMBLY LH
REMOVE INNER ROOF SIDE GARNISH ASSEMBLY RH
REMOVE NO. 1 AMPLIFIER ANTENNA ASSEMBLY
Bolt | |
Connector |
Disconnect the 2 connectors.
Remove the bolt.
Detach the guide and remove the No. 1 amplifier antenna assembly.
REMOVE NO. 2 AMPLIFIER ANTENNA ASSEMBLY
Bolt | |
Connector |
Disconnect the 2 connectors.
Remove the bolt.
Detach the guide and remove the No. 2 amplifier antenna assembly.