DESCRIPTION
This is the power source circuit to operate the radio receiver assembly.
WIRING DIAGRAM
CAUTION / NOTICE / HINT
Note
Inspect the fuses for circuits related to this system before performing the following inspection procedure.
PROCEDURE
CHECK HARNESS AND CONNECTOR (RADIO RECEIVER ASSEMBLY POWER SOURCE)
Disconnect the O159 and O158 radio receiver assembly connector.
Measure the resistance according to the value(s) in the table below.
Standard Resistance | ||||||
---|---|---|---|---|---|---|
|
Measure the voltage according to the value(s) in the table below.
Standard Voltage | ||||||||||||
---|---|---|---|---|---|---|---|---|---|---|---|---|
|
*1: w/o Stop and Start System
*2: w/ Stop and Start System
Result | ||||||||
---|---|---|---|---|---|---|---|---|
|
A |
PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE Click here |
B |
REPAIR OR REPLACE HARNESS OR CONNECTOR |
C |
GO TO STOP AND START SYSTEM Click here |