CAUTION / NOTICE / HINT
Tech Tips
Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed or replaced during the radio antenna cord removal /installation are shown below.
Replacement Part or Procedure | Necessary Procedures | Effects / Inoperative when not Performed | Link |
---|---|---|---|
Disconnect cable from negative battery terminal | Drive the vehicle until stop and start control is permitted (approximately 5 to 60 minutes) | Stop and start system | |
Memorize steering angle neutral point | Pre-collision system |
CAUTION:
w/ Airbag System:
Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.
PROCEDURE
PRECAUTION
Note
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.
DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
Note
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.
REMOVE UPPER INSTRUMENT PANEL SUB-ASSEMBLY
REMOVE ANTENNA CORD SUB-ASSEMBLY (for RHD)
w/o Navigation System:
Disconnect the connector.
Detach the clamps shown in the illustration.
Remove the bolt and antenna cord sub-assembly.
w/ Navigation System:
Disconnect the connector.
Detach the clamps shown in the illustration.
Remove the bolt and antenna cord sub-assembly.
REMOVE ANTENNA CORD SUB-ASSEMBLY (for LHD)
w/o Navigation System:
Disconnect the connector.
Detach the clamps shown in the illustration.
Remove the bolt and antenna cord sub-assembly.
w/ Navigation System:
Disconnect the connector.
Detach the clamps shown in the illustration.
Remove the bolt and antenna cord sub-assembly.
REMOVE ROOF HEADLINING ASSEMBLY
for Single Cab:
for Smart Cab:
for Double Cab:
REMOVE NO. 2 ANTENNA CORD SUB-ASSEMBLY
w/o Digital Audio Broadcasting Antenna
Disconnect the connectors.
Detach the clamps and remove the No. 2 antenna cord sub-assembly.
w/ Digital Audio Broadcasting Antenna
Disconnect the connectors and remove the bolt.
Detach the clamps, guide and remove the No. 2 antenna cord sub-assembly.