CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during front power seat switch removal/installation are shown below.
Replaced Part or Performed Procedure | Necessary Procedure | Effect/Inoperative Function when Necessary Procedure not Performed | Link |
---|---|---|---|
Disconnect cable from negative battery terminal | Perform steering sensor zero point calibration | Lane departure alert system (w/ Steering Control) | |
Pre-collision system | |||
Memorize steering angle neutral point | Parking assist monitor system | ||
|
Initialize position control ECU | Front power seat control system |
CAUTION:
Be sure to read Precaution thoroughly before servicing.
Wear protective gloves. Sharp areas on the parts may injure your hands.
Tech Tips
Use the same procedure for RHD and LHD vehicles.
The following procedure is for LHD vehicles.
Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
PROCEDURE
REMOVE FRONT SEAT ASSEMBLY
DISCONNECT SEPARATE TYPE FRONT SEATBACK COVER
REMOVE FRONT SEAT FRONT CUSHION SHIELD
REMOVE FRONT SEAT CUSHION SHIELD
w/o Vertical Adjuster:
w/ Vertical Adjuster:
REMOVE SLIDE AND VERTICAL POWER SEAT SWITCH KNOB
REMOVE RECLINING POWER SEAT SWITCH KNOB
REMOVE SEAT ADJUSTER SHIELD CLAMP BRACKET (w/ Vertical Adjuster)
REMOVE FRONT POWER SEAT SWITCH
w/o Vertical Adjuster:
Remove the 3 screws and front power seat switch from the front seat cushion shield.
w/ Vertical Adjuster:
Remove the 2 screws and front power seat switch from the front seat cushion shield.