CAUTION / NOTICE / HINT
Tech Tips
The following procedure is for the LH side.
Other than areas where instructions are provided, use the same procedure for the LH and RH sides.
PROCEDURE
INSTALL DISC BRAKE AIR GUIDE PLATE
Install disc brake air guide plate to the steering knuckle LH.
INSTALL FRONT AXLE HUB SUB-ASSEMBLY LH
Using a hexagon socket wrench 12 mm, install the front axle hub sub-assembly LH with the 4 bolts.
CONNECT STEERING KNUCKLE LH
TEMPORARILY TIGHTEN LOWER NO. 2 SUSPENSION ARM ASSEMBLY LH
Insert the bolt from the back of the vehicle. Then temporarily tighten the lower No. 2 suspension arm assembly LH with the nut.
TEMPORARILY TIGHTEN FRONT SHOCK ABSORBER ASSEMBLY LH
CONNECT FRONT STABILIZER LINK ASSEMBLY LH
CONNECT FRONT HEIGHT CONTROL SENSOR SUB-ASSEMBLY LH
TEMPORARILY TIGHTEN FRONT LOWER SUSPENSION ARM ASSEMBLY LH
Temporarily tighten the front lower suspension arm assembly LH to the steering knuckle assembly LH with the nut.
CONNECT TIE ROD ASSEMBLY LH
INSTALL FRONT DISC BRAKE DUST COVER LH
Install the front disc brake dust cover LH with the 3 bolts.
INSPECT FRONT AXLE HUB BEARING LOOSENESS
INSPECT FRONT AXLE HUB RUNOUT
INSTALL FRONT DISC LH
CONNECT DISC BRAKE CYLINDER ASSEMBLY
Temporarily install the 5 hub nuts to the front axle hub LH to secure the front disc LH.
Note
Do not apply excessive force to the flexible hose.
Temporarily install the disc brake cylinder assembly LH with the bolt on the lower side of the disc brake cylinder assembly LH.
Remove the SST.
Install the disc brake cylinder assembly LH with the bolt (A) and bolt (B).
Install the front flexible hose bracket LH to the steering knuckle with the bolt.
Connect the flexible hose to the front flexible hose bracket LH with the bolt.
for RH side:
Attach the guide to connect the pad wear indicator wire assembly.
CONNECT FRONT SKID CONTROL SENSOR WIRE
for LH Side:
Install the sensor clamp with the bolt.
Note
Do not twist the skid control sensor wire when installing it.
Connect the skid control sensor wire connector.
for RH Side:
Install the sensor clamp with the bolt.
Note
Do not twist the skid control sensor wire when installing it.
Connect the skid control sensor wire connector.
Connect the pad wear indicator connector.
Install the sensor clamp with the nut.
Note
Do not twist the skid control sensor wire when installing it.
STABILIZE SUSPENSION
FULLY TIGHTEN LOWER NO. 2 SUSPENSION ARM ASSEMBLY LH
Tighten the installation bolt of the lower No. 2 suspension arm assembly LH.
FULLY TIGHTEN FRONT LOWER SUSPENSION ARM ASSEMBLY LH
Tighten the installation nut of the steering knuckle assembly LH.
Note
Further tighten the nut up to 60° if the holes for the clip are not aligned.
Install a new clip.
FULLY TIGHTEN FRONT SHOCK ABSORBER ASSEMBLY LH
Fully tighten the front shock absorber assembly bolt.
Note
Because the nut has its own stopper, do not turn the nut. Tighten the bolt with the nut secured.
INSTALL REAR LOWER ARM MOUNTING REINFORCEMENT SUB-ASSEMBLY LH
INSTALL ENGINE SIDE COVER LH
INSTALL NO. 2 ENGINE UNDER COVER ASSEMBLY
INSTALL FRONT WHEEL
CONNECT BRAKE BOOSTER PUMP CONNECTOR
CHECK FOR SPEED SENSOR SIGNAL
INSPECT AND ADJUST FRONT WHEEL ALIGNMENT
ADJUST HEADLIGHT AIMING
ADJUST REAR TELEVISION CAMERA ASSEMBLY OPTICAL AXIS