CAUTION / NOTICE / HINT
Tech Tips
Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
PROCEDURE
INSTALL STOP LIGHT SWITCH MOUNTING ADJUSTER
Attach the claw to install a new stop light switch mounting adjuster.
INSTALL STOP LIGHT SWITCH ASSEMBLY
Insert the stop light switch assembly to the stop light switch mounting adjuster until the switch body slightly touches the brake pedal.
Note
Do not depress the brake pedal.
*a | Protrusion Amount Measurement Area |
Rotate the stop light switch assembly clockwise by approximately one fourth of a rotation.
Check the protrusion amount of the shaft.
Standard |
---|
1.5 to 2.6 mm (0.0591 to 0.1024 in.) |
Connect the connector.
INSTALL DRIVER SIDE JUNCTION BLOCK ASSEMBLY WITH MAIN BODY ECU (for LHD)
INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY (for RHD)
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL (for LHD)
Note
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
INSTALL NO. 2 DECK BOARD (for LHD)
PERFORM DIAGNOSTIC SYSTEM CHECK (for LHD)
CHECK SRS WARNING LIGHT (for LHD)