CAUTION / NOTICE / HINT
Tech Tips
If the bumper is damaged, there is a possibility that the installation area of the blind spot monitor sensor may be deformed and the blind spot monitor system may not operate correctly, so visually inspect the blind spot monitor sensor installation area (frame, stud bolt) to make sure it is not dented or bent.
If the visual inspection finds a problem, check the installation condition of the blind spot monitor sensor, and adjust the installation position of the blind spot monitor sensor as necessary.
Use the same procedure for the RH and LH sides.
The procedure described below is for the LH side.
PROCEDURE
REMOVE NO. 1 DECK BOARD
REMOVE NO. 2 DECK BOARD
REMOVE ROPE HOOK ASSEMBLY
Tech Tips
Use the same procedure to remove the rope hook assembly on the other side.
Open |
Detach the claw to open the 2 rope hook caps.
Remove the 2 bolts and 2 rope hook assemblies.
REMOVE LUGGAGE COMPARTMENT TRIM COVER LH
REMOVE LUGGAGE COMPARTMENT TRIM COVER RH
REMOVE SIDE TRIM BOX
REMOVE LUGGAGE COMPARTMENT TRIM BOX
REMOVE REAR FLOOR FINISH PLATE
REMOVE LUGGAGE COMPARTMENT TRIM INNER COVER LH
Remove the 3 clips.
Remove the back side of the luggage compartment trim inner cover LH.
REMOVE REAR BUMPER ASSEMBLY
REMOVE REAR BUMPER CORNER EXTENSION LH
REMOVE REAR COMBINATION LIGHT ASSEMBLY LH
Disconnect the connector.
Remove the nut.
Remove the 8 bolts.
Place your hand at the location shown in the illustration and pull the rear combination light assembly LH toward the rear of the vehicle to detach the pin and clip to remove it.
Note
Pull the rear combination light assembly LH straight towards the rear of the vehicle to prevent the guide from becoming damaged.
Place Hands Here | Remove in this Direction |
Pull Out |
Disconnect the grommet and pull out the wire harness.