CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed or replaced during the microphone removal/installation are shown below.
Replacement Part or Procedure | Necessary Procedures | Effects / Inoperative when not Performed | Link |
---|---|---|---|
Disconnect cable from negative battery terminal | Memorize steering angle neutral point | LKA/LDA system | |
Pre-collision system | |||
Parking assist monitor system | |||
Steering sensor zero point calibration | Variable gear ratio steering system | ||
|
Initialize position control ECU | Front Power Seat Control System |
CAUTION:
Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.
PROCEDURE
PRECAUTION
Note
After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.
REMOVE NO. 2 DECK BOARD
DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
the airbag deploys for any reason, it may cause a serious accident.
Note
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
REMOVE ROOF HEADLINING ASSEMBLY
REMOVE TELEPHONE MICROPHONE ASSEMBLY
for Glass Roof:
Disconnect the connector.
Detach the claws and remove the telephone microphone assembly.
for Carbon Roof:
Disconnect the connector.
Detach the claws and remove the telephone microphone assembly.