ENTRY AND START SYSTEM(for Start Function) DTC CHECK / CLEAR

Note

If the GTS is connected to the vehicle with the engine switch off, the information stored in entry and start system related ECUs (the certification ECU and main body ECU) cannot be read. However, entry and start system DTCs and Data List information can be confirmed even if the engine switch is off using the method below:


  • Connect the GTS to the vehicle, and turn a courtesy light switch on and off at intervals of 1.5 seconds or less until communication between the GTS and vehicle begins (the GTS screen changes when communication begins).

  • Connect the GTS to the vehicle and select "MANUAL" from the initial screen on the GTS. Select "KEY REGIST" under Model Code.


  1. CHECK DTC (POWER SOURCE CONTROL)


    1. Connect the GTS to the DLC3.

    2. Turn the engine switch on (IG).

    3. Turn the GTS on.

    4. Enter the following menus: Body Electrical / Power Source Control / DTC.

    5. Check for DTCs.

      Tech Tips

      Refer to the GTS operator's manual for further details.

  2. CHECK DTC (STARTING CONTROL)


    1. Connect the GTS to the DLC3.

    2. Turn the engine switch on (IG).

    3. Turn the GTS on.

    4. Enter the following menus: Body Electrical / Starting Control / DTC.

    5. Check for DTCs.

      Tech Tips

      Refer to the GTS operator's manual for further details.

  3. CHECK DTC (ENTRY AND START)


    1. Connect the GTS to the DLC3.

    2. Turn the engine switch on (IG).

    3. Turn the GTS on.

    4. Enter the following menus: Body Electrical / Entry & Start / DTC.

    5. Check for DTCs.

      Tech Tips

      Refer to the GTS operator's manual for further details.

  4. CLEAR DTC (POWER SOURCE CONTROL)


    1. Connect the GTS to the DLC3.

    2. Turn the engine switch on (IG).

    3. Turn the GTS on.

    4. Enter the following menus: Body Electrical / Power Source Control / DTC.

    5. Clear the DTCs by following the directions on the GTS display.

      Tech Tips

      Refer to the GTS operator's manual for further details.

  5. CLEAR DTC (STARTING CONTROL)


    1. Connect the GTS to the DLC3.

    2. Turn the engine switch on (IG).

    3. Turn the GTS on.

    4. Enter the following menus: Body Electrical / Starting Control / DTC.

    5. Clear the DTCs by following the directions on the GTS display.

      Tech Tips

      Refer to the GTS operator's manual for further details.

  6. CLEAR DTC (ENTRY AND START)


    1. Connect the GTS to the DLC3.

    2. Turn the engine switch on (IG).

    3. Turn the GTS on.

    4. Enter the following menus: Body Electrical / Entry & Start / DTC.

    5. Clear the DTCs by following the directions on the GTS display.

      Tech Tips

      Refer to the GTS operator's manual for further details.