POP UP HOOD SENSOR REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed or replaced during the pedestrian detection chamber assembly removal/installation are shown below.

Necessary Procedures after parts removed / installed / replaced
Replacement Part or Procedure Necessary Procedures Effects / Inoperative when not Performed Link
Disconnect cable from negative (-) auxiliary battery terminal Memorize steering angle neutral point LKA/LDA system

Click here

Pre-collision system
Parking assist monitor system

Click here

Steering sensor zero point calibration Variable gear ratio steering system

Click here

PROCEDURE


  1. PRECAUTION

    CAUTION:

    Be sure to read precaution thoroughly before servicing.

    Click here

    B004CGW

    Note

    After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work.

    Click here

  2. REMOVE NO. 2 DECK BOARD

    Click here

  3. DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

    Click here

    CAUTION:


    • Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.

    • If the airbag deploys for any reason, it may cause a serious accident.

    B004A52

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  4. REMOVE FRONT BUMPER ASSEMBLY

    Click here

  5. REMOVE FRONT NO. 2 BUMPER MOUNTING BRACKET

    Click here

  6. REMOVE PEDESTRIAN DETECTION CHAMBER ASSEMBLY

    Note

    When inspect the pedestrian detection chamber assembly, do not remove the pedestrian protection sensor.


    • The installation bolt and nut for the pedestrian protection sensor is a non-reusable part.

    • To preserve the airtight seal of the pedestrian detection chamber.

    • Do not open/close or move the tightening clips of the pedestrian detection chamber and pedestrian protection sensor.


    1. B004ANVC01
      *1 Pedestrian Protection Sensor
      B004C4F Bolt
      B004ANI Nut

      Remove the bolt, nut and the pedestrian detection chamber assembly from the No. 2 front bumper mounting bracket.

      Note


      • When inspect the pedestrian detection chamber assembly, do not remove the pedestrian protection sensor.

      • Do not subject the pedestrian protection sensor to any strong impact (such as dropping).

      • If the pedestrian detection sensor is subjected to any strong impact, replace the pedestrian detection chamber assembly with a new one.

      • Hold the pedestrian protection sensor so as not to damage the No. 2 front bumper mounting bracket.

      Tech Tips

      Use the same procedure for the other side.

  7. REMOVE FRONT BUMPER ENERGY ABSORBER


    1. Remove the 4 clips.

    2. Detach the guides and remove the front bumper energy absorber from the No. 2 front bumper mounting bracket.

      Note

      When remove the front energy absorber assembly, do not pull the pedestrian detection chamber.

      B004C0J
    3. Remove the pedestrian detection chamber assembly from the front bumper energy absorber.

      Note


      • When remove the pedestrian detection chamber, take care not to damage the front bumper energy absorber.

      • If the front bumper energy absorber has been damaged, replace it with a new one.

      B004A7H