CAUTION / NOTICE / HINT
Tech Tips
If the bumper is damaged, there is a possibility that the installation area of the blind spot monitor sensor may be deformed and the blind spot monitor system may not operate correctly, so visually inspect the blind spot monitor sensor installation area (frame, stud bolt) to make sure it is not dented or bent.
If the visual inspection finds a problem, check the installation condition of the blind spot monitor sensor, and adjust the installation position of the blind spot monitor sensor as necessary.
PROCEDURE
REMOVE REAR BUMPER ASSEMBLY
REMOVE BACK-UP LIGHT ASSEMBLY
Screw | |
Connector | |
Double-sided Tape Application Area |
Disconnect the connector.
Remove the 2 screws.
Remove the 2 pieces of double-sided tape and the back-up light assembly.