CAUTION / NOTICE / HINT
Tech Tips
Use the same procedures for the RH side and LH side.
The procedures listed below are for the LH side.
PROCEDURE
PRECAUTION
Note
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.
DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
Note
When disconnecting the cable some systems need to be initialized after the cable is reconnected Click here.
REMOVE FRONT DOOR INSIDE HANDLE BEZEL PLUG LH
REMOVE ASSIST GRIP COVER LH
REMOVE POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL
REMOVE FRONT DOOR NO. 1 STIFFENER CUSHION
REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH
REMOVE FRONT DOOR INNER GLASS WEATHERSTRIP LH
REMOVE FRONT DOOR SERVICE HOLE COVER LH
REMOVE FRONT DOOR GLASS SUB-ASSEMBLY LH
REMOVE FRONT DOOR BELT MOULDING LH
*1 | Protective Tape |
*2 | Claw A |
Put protective tape around the front door belt moulding.
Detach the 8 claws and remove the front door belt moulding.
Tech Tips
If either of the claws labeled A is damaged, replace the front door belt moulding with a new one.