CAUTION / NOTICE / HINT
CAUTION:
Wear protective gloves. Sharp areas on the parts may injure your hands.
Tech Tips
Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
PROCEDURE
PRECAUTION
Note
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.
DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
Note
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.
REMOVE FRONT SEAT HEADREST ASSEMBLY
*1 | Protective Tape |
Using a screwdriver, push the headrest support lock to release the lock and remove the front seat headrest assembly.
Tech Tips
Tape the screwdriver tip before use.
REMOVE FRONT SEAT REAR INNER TRACK COVER
Lift up the seat track adjusting handle and move the front seat assembly to the foremost position.
Detach the 2 claws and remove the front seat rear inner track cover.
REMOVE FRONT SEAT REAR OUTER TRACK COVER
Detach the 2 claws and remove the front seat rear outer track cover.
REMOVE FRONT SEAT INNER TRACK BRACKET COVER
Lift up the seat track adjusting handle and move the front seat assembly to the rearmost position.
Detach the 4 claws and remove the front seat inner track bracket cover.
REMOVE FRONT SEAT OUTER TRACK BRACKET COVER
Detach the 4 claws and remove the front seat outer track bracket cover.
REMOVE FRONT SEAT ASSEMBLY
Remove the 2 bolts.
Lift up the seat track adjusting handle and move the front seat assembly to the foremost position.
Remove the 2 bolts.
Lift up the seat track adjusting handle and move the front seat assembly to the center position. Also, operate the reclining adjuster release handle and move the seatback to the upright position.
Disconnect the connectors under the front seat assembly.
Remove the front seat assembly as shown in the illustration.
Note
Make sure the seatback does not contact the shift lever knob.
Be careful not to damage the vehicle body.
Tech Tips
Remove the front seat assembly through the door frame so that it passes under the steering wheel.