CAUTION / NOTICE / HINT
Tech Tips
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
PROCEDURE
INSTALL REAR AXLE HUB AND BEARING ASSEMBLY LH (SKID CONTROL SENSOR)
Install the rear axle hub and bearing LH Click here.
INSTALL SKID CONTROL SENSOR WIRE
Note
To prevent interference with other parts, do not twist the painted line areas of the sensor wire when installing it.
Connect the skid control sensor wire connector to the skid control sensor.
Attach the sensor clamp.
Note
Do not twist the sensor wire when installing the clamp.
Install the sensor clamp with the bolt.
Note
Do not twist the sensor wire when installing the clamp.
Install the sensor clamp with the bolt.
Note
Do not twist the sensor wire when installing the clamp.
*1 | Grommet |
*2 | Band Clamp |
*3 | Connector |
*a | Inside of Vehicle |
Insert the connector and grommet into the inside of the vehicle through the hole in the wheel house.
Note
Make sure the band clamp remains on the outside of the vehicle.
*a | Outside of Vehicle |
*b | 30° |
Hold the grommet and pull it toward the outside of the vehicle. Then fix the grommet in place so that it is not tilted.
Note
When pulling out the grommet, do not grip the sensor wire.
Fix the grommet in place within the range shown in the illustration.
Connect the skid control sensor wire connector to the vehicle side connector on the rear floor.
INSTALL REAR SEAT ASSEMBLY
for Sedan:
Install the rear seat assembly Click here.
for Wagon:
Install the rear seat assembly Click here.
INSTALL REAR WHEEL
CHECK SPEED SENSOR SIGNAL
Check the speed sensor signal Click here.