CAUTION / NOTICE / HINT
Tech Tips
Use the same procedures for the RH side and LH side.
The procedures listed below are for the LH side.
PROCEDURE
REMOVE REAR DISC BRAKE CYLINDER ASSEMBLY LH
Remove the rear disc brake cylinder assembly LH Click here.
REMOVE REAR DISC
INSPECT REAR AXLE HUB BEARING LOOSENESS
Using a dial indicator, check for looseness near the center of the axle hub.
Maximum looseness |
---|
0.05 mm (0.00197 in.) |
Note
Make sure that the dial indicator is set perpendicular to the measurement surface.
Tech Tips
If the looseness more than the maximum, replace the axle hub assembly.
INSPECT REAR AXLE HUB RUNOUT
Using a dial indicator, check for runout on the surface of the axle hub inside the rear axle hub bolts.
Maximum runout |
---|
0.08 mm (0.00314 in.) |
Note
Make sure that the dial indicator is set perpendicular to the measurement surface.
Make sure to set the tip of the dial indicator inside the rear axle hub bolts.
If the runout more than the maximum, replace the rear axle hub and bearing assembly.
INSTALL REAR DISC
INSTALL REAR DISC BRAKE CYLINDER ASSEMBLY LH
Install the rear disc brake cylinder assembly LH Click here.