PROCEDURE
REMOVE FRONT BUMPER REINFORCEMENT
REMOVE NO. 1 ENGINE COVER
REMOVE NO. 1 ENGINE UNDER COVER
Remove the 6 bolts, 11 clips and No. 1 engine under cover.
REMOVE FRONT LOWER BUMPER ABSORBER
Remove the 4 bolts.
Detach the 2 hooks of the front lower bumper absorber from the installation holes in the body and remove the front lower bumper absorber.
RECOVER REFRIGERANT FROM REFRIGERATION SYSTEM (w/ Air Conditioning System)
for HFC-134a(R134a):
for HFO-1234yf(R1234yf):
DRAIN ENGINE COOLANT
PRECAUTION
Note
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.
DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
Note
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.
DISCONNECT CABLE FROM POSITIVE BATTERY TERMINAL
REMOVE BATTERY CLAMP SUB-ASSEMBLY
REMOVE BATTERY INSULATOR
REMOVE BATTERY
REMOVE BATTERY TRAY
REMOVE BATTERY CARRIER
DISCONNECT AMBIENT TEMPERATURE SENSOR
REMOVE RADIATOR SIDE DEFLECTOR RH
Detach the 3 claws and remove the radiator side deflector RH.
REMOVE RADIATOR SIDE DEFLECTOR LH
Detach the 3 claws and remove the radiator side deflector LH.
DISCONNECT NO. 2 WATER BY-PASS HOSE
Detach the 3 clamps to disconnect the No. 2 water by-pass hose from the 2 hose clamp brackets and No. 1 water hose clamp bracket.
DISCONNECT NO. 3 WATER BY-PASS HOSE
Detach the clamp to disconnect the No. 3 water by-pass hose from the fan shroud.
Slide the hose clamp and disconnect the No. 3 water by-pass hose from the radiator assembly.
DISCONNECT NO. 1 RADIATOR HOSE
Slide the hose clamp and disconnect the No. 1 radiator hose from the radiator assembly.
DISCONNECT NO. 2 AIR HOSE
Loosen the hose clamp and disconnect the No. 2 air hose from the intercooler assembly.
DISCONNECT NO. 3 AIR HOSE
Loosen the hose clamp and disconnect the No. 3 air hose from the intercooler assembly.
DISCONNECT NO. 2 RADIATOR HOSE
*a | Push |
Open the water hose hose clamp and disconnect the No. 2 radiator hose from the water by-pass hose sub-assembly.
*a | Retainer |
Pull out the retainer and disconnect the No. 2 radiator hose from the water inlet.
DISCONNECT DISCHARGE HOSE SUB-ASSEMBLY (w/ Air Conditioning System)
DISCONNECT SUCTION PIPE SUB-ASSEMBLY (w/ Air Conditioning System)
REMOVE UPPER RADIATOR SUPPORT
Remove the 2 bolts and 2 upper radiator supports.
REMOVE UPPER RADIATOR SUPPORT SUB-ASSEMBLY
Remove the 2 cushions.
Remove the 4 bolts and 2 upper radiator support sub-assemblies.
REMOVE HOOD LOCK ASSEMBLY
REMOVE HOOD LOCK SUPPORT SUB-ASSEMBLY
Detach the clamp to disconnect the hood lock control cable assembly from the hood lock support sub-assembly.
Remove the 5 bolts and hood lock support sub-assembly.
REMOVE RADIATOR GRILLE BRACKET
Disconnect 2 connectors from the 2 horns.
Remove the bolt and radiator grille bracket.
REMOVE CONDENSER ASSEMBLY WITH RECEIVER (w/ Air Conditioning System)
REMOVE RADIATOR ASSEMBLY
Disconnect the 2 connectors and detach the clamp.
Remove the radiator assembly from the vehicle together with the intercooler assembly.
Note
Do not allow the radiator assembly to interfere with other parts.
Remove the 2 cushions.
REMOVE NO. 2 RADIATOR HOSE
Slide the hose clamp and remove the No. 2 radiator hose from the radiator assembly.
REMOVE LOWER RADIATOR SUPPORT SUB-ASSEMBLY
REMOVE INTERCOOLER ASSEMBLY
REMOVE FAN SHROUD
Remove the 2 bolts and fan shroud.