EXHAUST PIPE INSTALLATION

PROCEDURE


  1. INSTALL FRONT EXHAUST PIPE ASSEMBLY


    1. Check the free length of the compression spring.


      1. A004PIR

        Using a vernier caliper, measure the free length of the compression spring.

        Minimum length
        41.5 mm (1.63 in.)

        If the free length is less than the minimum, replace the compression spring.

    2. Connect the front exhaust pipe to the 2 exhaust pipe supports.

    3. Install a new gasket to the front exhaust pipe.

    4. Install the front exhaust pipe and 2 compression springs with the 2 bolts.

      Torque:
      43 N*m  { 438 kgf*cm, 32 ft.*lbf }
  2. INSTALL AIR FUEL RATIO SENSOR

    Click here

  3. INSTALL FRONT FLOOR CENTER BRACE


    1. A004S44

      Install the front floor center brace with the 4 bolts.

      Torque:
      51 N*m  { 520 kgf*cm, 38 ft.*lbf }
  4. INSTALL NO. 2 ENGINE UNDER COVER


    1. A004OLP

      Install the No. 2 engine under cover with the 4 clips.

  5. INSTALL TAILPIPE ASSEMBLY


    1. Check the free length of the compression spring.


      1. A004PIR

        Using a vernier caliper, measure the free length of the compression spring.

        Minimum length
        38.5 mm (1.52 in.)

        If the free length is less than the minimum, replace the compression spring.

    2. Connect the tailpipe to the 4 exhaust pipe supports.

    3. Install a new gasket to the front exhaust pipe.

    4. Install the tailpipe and 2 compression springs with the 2 bolts.

      Torque:
      43 N*m  { 438 kgf*cm, 32 ft.*lbf }
  6. INSPECT FOR EXHAUST GAS LEAK


    1. Check that there are no exhaust gas leaks from the points (connection areas of the exhaust pipes and installation areas of each sensor) shown in the illustration.

      A004TN0