PROCEDURE
PERFORM REGISTRATION
PRECAUTION
Note
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.
DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
Note
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.
REMOVE NO. 1 ENGINE COVER
REMOVE RADIATOR SUPPORT OPENING COVER
REMOVE AIR CLEANER CAP SUB-ASSEMBLY
Disconnect the mass air flow meter connector and detach the wire harness clamp.
Detach the 2 clamps.
Loosen the hose clamp and remove the air cleaner cap sub-assembly.
REMOVE AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY
REMOVE AIR CLEANER CASE SUB-ASSEMBLY
REMOVE NO. 1 AIR CLEANER INLET
Remove the clip and No. 1 air cleaner inlet.
REMOVE NO. 2 AIR CLEANER INLET
Remove the bolt and No. 2 air cleaner inlet.
REMOVE ECM
Push in the locks on the 2 levers, raise the levers and disconnect the 2 ECM connectors.
Push |
Note
After disconnecting the ECM connectors, make sure that dirt, water or other foreign matter does not contact the connecting parts of the ECM connectors.
Remove the 2 bolts and ECM with bracket
Remove the 2 screws and No. 1 ECM bracket.
Remove the 2 screws and No. 2 ECM bracket.