CAUTION / NOTICE / HINT
CAUTION:
Wear protective gloves. Sharp areas on the parts may injure your hands.
Tech Tips
Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
PROCEDURE
INSTALL FRONT SEAT ASSEMBLY
Install the front seat assembly as shown in the illustration.
Note
Be careful not to damage the vehicle body.
Make sure the seatback does not contact the shift lever knob.
Make sure the power seat switch knob does not contact the center pillar.
Tech Tips
Install the front seat assembly through the door frame so that it passes under the steering wheel.
Connect the connectors under the front seat assembly.
Connect the cable to the negative (-) battery terminal.
Note
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.
Temporarily install the front seat assembly with the 4 bolts.
Operate the power seat switch (slide switch) to move the front seat assembly to the foremost position.
Tighten the 2 bolts in the order shown in the illustration.
Operate the power seat switch (slide switch) to move the front seat assembly to the rearmost position.
Tighten the 2 bolts in the order shown in the illustration.
INSTALL FRONT SEAT OUTER TRACK BRACKET COVER
Attach the 4 claws to install the front seat outer track bracket cover.
INSTALL FRONT SEAT INNER TRACK BRACKET COVER
Attach the 4 claws to install the front seat inner track bracket cover.
INSTALL FRONT SEAT REAR OUTER TRACK COVER
Operate the power seat switch (slide switch) to move the front seat assembly to the foremost position.
Attach the 2 claws to install the front seat rear outer track cover.
INSTALL FRONT SEAT REAR INNER TRACK COVER
Attach the 2 claws to install the front seat rear inner track cover.
INSTALL FRONT SEAT HEADREST ASSEMBLY
Install the front seat headrest assembly.
CHECK SRS WARNING LIGHT
INSPECT FRONT SEAT ASSEMBLY
Check the power seat operation Click here.
Check the seat heater operation.
Turn the ignition switch to ON.
Operate the seat heater switch on.
Wait 5 minutes or more and confirm that the seat surface becomes warm.