PROCEDURE
PRECAUTION
Note
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.
DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
Note
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.
REMOVE LOWER NO. 2 INSTRUMENT PANEL FINISH PANEL
REMOVE LOWER NO. 1 INSTRUMENT PANEL FINISH PANEL
REMOVE NO. 3 BOX PANEL
REMOVE INSTRUMENT PANEL FINISH PANEL END LH
REMOVE INSTRUMENT PANEL FINISH PANEL END RH (for LHD)
REMOVE INSTRUMENT PANEL FINISH PANEL END RH (for RHD)
REMOVE CENTER INSTRUMENT PANEL REGISTER ASSEMBLY WITH FINISH PANEL
REMOVE RADIO RECEIVER ASSEMBLY WITH BRACKET (for Radio Receiver Type)
Remove the 4 screws.
Pull the radio receiver to detach the 4 clips and 2 claws on the backside of the radio receiver with bracket.
Disconnect the connectors and remove the radio receiver with bracket.
REMOVE RADIO AND DISPLAY RECEIVER ASSEMBLY WITH BRACKET (for Radio and Display Type)
Remove the 4 screws.
Pull the radio receiver to detach the 4 clips and 2 claws on the backside of the radio and display receiver assembly with bracket.
Disconnect the connectors and remove the radio and display receiver assembly with bracket.
REMOVE NO. 1 RADIO BRACKET (for Radio Receiver Type)
Remove the 3 screws and No. 1 radio bracket.
REMOVE NO. 1 RADIO RECEIVER BRACKET (for Radio and Display Type)
Remove the 3 screws and No. 1 radio receiver bracket.
REMOVE NO. 2 RADIO BRACKET (for Radio Receiver Type)
Remove the 3 screws and No. 2 radio bracket.
REMOVE NO. 2 RADIO RECEIVER BRACKET (for Radio and Display Type)
Remove the 3 screws and No. 2 radio receiver bracket.