PROCEDURE
INSPECT FUEL INJECTOR ASSEMBLY
*1 | Component without harness connected (Fuel Injector Assembly) |
Check the resistance.
Measure the resistance according to the value(s) in the table below.
Standard Resistance | ||||||
---|---|---|---|---|---|---|
|
If the result is not as specified, replace the injector assembly.
Check the injection volume.
CAUTION:
Perform the inspection in a well-ventilated area.
Do not perform the inspection near any naked flames.
*1 | Fuel Pipe |
*a | SST (Fuel Tube Connector) |
*b | SST (Hose) |
*c | SST (Hose Band) |
Connect SST (fuel tube connector) to SST (hose) with SST (hose band), and then connect them to the fuel pipe (vehicle side).
*1 | O-Ring |
*2 | Vinyl Tube |
*a | SST (Hose Band) |
*b | SST (Adapter) |
*c | SST (Hose) |
*d | SST (Clamp) |
Install the O-ring onto the fuel injector assembly.
Connect SST (adapter and hose) to the injector assembly, and hold the injector assembly and union with SST (clamp).
*1 | Lock |
*a | SST (Tie Band) |
Pass SST (tie band) through the loop on the handle of SST (clamp) to secure SST (clamp) to SST (adapter).
Note
As SST (tie band) does not completely prevent SST (clamp) from becoming loose, do not subject the parts to any impacts while using them.
Before using SST (tie band), make sure that there is no deterioration, damage or cracks. If there are any abnormalities, replace SST.
Tech Tips
When removing SST (tie band), disengage the lock.
Check that SST (clamp) and SST (adapter) cannot be easily separated.
Install a vinyl tube onto the injector.
Note
Install a suitable vinyl tube onto the injector to prevent gasoline from splashing out.
Put the injector into a graduated cylinder.
Operate the fuel pump Click here.
Connect SST (wire) to the injector and battery for 15 seconds, and measure the injection volume with the graduated cylinder. Test each injector 2 or 3 times.
Standard injection volume |
---|
60 to 73 cc (3.7 to 4.5 cu. in.) per 15 seconds |
Difference between each injector |
---|
13 cc (0.8 cu. in.) or less |
Connect |
Note
Always do the switching at the battery side.
If the injection volume is not as specified, replace the injector assembly.
Inspect for fuel leak.
In the condition above, disconnect the test probes of SST (wire) from the battery and check the fuel leakage from the injector.
Standard |
---|
1 drop or less every 12 minutes |