PROCEDURE
INSPECT TIRES
Check the tires for wear and proper inflation pressure.
Cold Tire Inflation Pressure | |||||||||
---|---|---|---|---|---|---|---|---|---|
|
*1: for Australia
Using a dial indicator, check the runout of the tires.
Maximum Tire Runout |
---|
1.4 mm (0.0551 in.) |
ROTATE TIRES
Rotate the tires as shown in the illustration.
Front |
INSPECT AND ADJUST WHEEL BALANCE
Inspect and adjust the off-the-car balance.
Maximum Imbalance |
---|
8.0 g (0.0176 lb) |
Note
Use a cleaning detergent to remove dirt, oil and water from the surface where the balance weight is to be adhered.
Do not touch the adhesive surface of the balance weight.
Adhere a stick-on type balance weight to the flat surface (A) shown in the illustration.
Width (A) |
---|
25 mm (0.984 in.) |
Push the balance weight securely with your finger to adhere it to the desired position.
Do not reuse balance weights.
Tech Tips
The inner side balance weight should be installed by clipping it to the rim.
INSPECT FRONT AXLE HUB AND BEARING
INSPECT REAR AXLE HUB AND BEARING