Note
When the diagnosis system is changed from normal mode to check mode or vice versa, all DTCs and freeze frame data recorded in normal mode are cleared. Before changing modes, always check and make a note of DTCs and freeze frame data.
Tech Tips
DTCs which are stored in the ECM can be displayed on the GTS. The GTS can display current and pending DTCs.
Some DTCs are not stored if the ECM does not detect the same malfunction again during a second consecutive driving cycle. However, such malfunctions, detected during only one driving cycle, are stored as pending DTCs.
CHECK DTC
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Enter the following menus: Powertrain / Transmission / Trouble Codes.
Check for DTC(s) and freeze frame data, and write them down.
Tech Tips
GTS Display | Description |
---|---|
Test Failed | Shows the malfunction judgment results during the current trip. |
Pending | Shows the malfunction judgment results up to now. (Indicates the possibility of a malfunction when no DTC is confirmed.) |
Confirmed | Shows the DTCs confirmed up to now. (The number of current trips differs for each DTC.) |
Check the details of the DTC(s).
CLEAR DTC (When Using GTS)
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Enter the following menus: Powertrain / Transmission / Clear DTCs.
Clear the DTCs.
CLEAR DTC (When not Using GTS)
Perform either of the following operations:
Note
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.
Disconnect the cable from the negative (-) battery terminal for more than 1 minute.
Remove the EFI-MAIN fuse and ETCS fuse from the No. 1 engine room relay block and No. 1 junction block assembly located inside the engine compartment for more than 1 minute.